[. . . ] -- If the adapter or the charging stand is damaged, always have it replaced with one of the original types in order to avoid a hazard. -- Do not use the appliance if the shaving head or one of the trimming combs is damaged or broken, as this may cause injury. -- This appliance is only intended for trimming and dry shaving facial hair (beard, moustache and sideburns). Compliance with standards -- The appliance complies with the internationally approved IEC safety regulations and can be safely used in the bath or shower. [. . . ] Shaving Before you use the shaving head, always check it for damage or wear. If the shaving head is damaged or worn, do not use it, as injury may occur. Replace a damaged shaving head before you use it again (see chapter ‘Replacement’). Shaving tips and tricks -- The shaving head is suitable for both wet and dry use. Note:We advise you to use the shaving head with shaving gel or foam when you use it for a wet shave. € -- Make sure that the shaving head is in full contact with the skin. -- You can switch on the shaving head while the trimming head is operating. € -- Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. 3 Rinse the shaving unit under the tap to ensure that the shaving unit glides smoothly over your skin. 4 Hold the appliance in the shaving position, with the shaving head pointing upwards and the trimming head pointing downwards. 5 Press the shaving head on/off button once to switch on the shaving head. , , QS6161 only: The on/off button lights up to indicate that the shaving head is operating. 6 Place the shaving head on the skin and move the appliance against the direction of hair growth while you press it lightly. Note: Rinse the shaving head under the tap regularly to ensure that it continues to glide smoothly over your skin. ENGLISH 7 To switch off the shaving head after use, press the shaving head on/ off button again. 8 Clean the shaving head (see chapter ‘Cleaning and maintenance’, section ‘Quick cleaning the shaving head after wet shaving’). 13 Dry shaving 1 Hold the appliance in the shaving position, with the shaving head pointing upwards and the trimming head pointing downwards. 2 Press the shaving head on/off button once to switch on the shaving head. , , QS6161 only: The on/off button lights up to indicate that the shaving head is operating. 3 Place the shaving head on the skin and move the appliance against the direction of hair growth while you press it lightly. 4 To switch off the shaving head after use, press the shaving head on/ off button again. 14 ENGLISH Overload protection If you press the trimming head or shaving head too hard onto your skin or if its cutters gets blocked (e. [. . . ] -- Hvis adapteren eller ladestativet blir skadet, må du alltid sørge for å bytte den ut med originale deler for å unngå at det oppstår farlige situasjoner. -- Dette Philips­ pparatet overholder alle aktuelle standarder og forskrifter a for eksponering for elektromagnetiske felt. 3 Trykk på innstillingsvelgeren for hårlengde, og beveg den deretter fra venstre til høyre eller høyre til venstre for å velge en innstilling. Bruk skjærehodet med barbergelé eller skum for ekstra komfort, eller bruk skjærehodet tørt for ekstra anvendelighet. [. . . ]